Automatic (PLC) Double Pallet Nailing Line

A) Upper Knife

Maximum trackable pallet size: 120 × 120 cm

Minimum trackable pallet size: 80 × 100 cm

Minimum nailing time: 3 to 5 pcs / min

Nails to be used in the nailing process: CASTING NAIL

Ability to drive nails in two different sizes – Three different sizes possible

Nail throwing unit PNEUMATIC and AUTOMATIC Nail driving unit HYDRAULIC

The automation equipment of the machine is PLC controlled.

21 pieces nail guns (number and spacing of guns can be changed upon request.)

Total electricity used in the machine: 21 KW

Width: 3140 mm- Length: 9200 mm- Height: 3050 mm

B) Rollover Unit

Total Electric Capacity: 2.95 KW

Width: 1760 mm- Length: 3500 mm- Height: 940 mm

Working system: mechanical

C) Lower Hammer

Maximum trackable pallet size: 120 × 120 cm

Minimum trackable pallet size: 80 × 100 cm

Minimum nailing time: 3 to 5 pcs / min

Nails to be used in the nailing process: CASTING NAIL

Ability to drive nails in two different sizes

Nail throwing unit: PNEUMATIC and AUTOMATIC

Nailers: HYDRAULIC

Machine automation equipment: PLC controlled.

9 nail guns (number and spacing of guns can be changed upon request.)

Total electricity used in the machine is 21 KW

Width: 3140 mm- cm Length: 6200 mm- Height: 2895 mm

D) Pallet Marking

It is the section that simultaneously marks the six wedges of the pallet at the same time.

-Brand Heating System: Electric Resistance

-Brand Printing System: Pneumatic -Brand Stamp: Chrome or bronze

-Resistance Electric Power: 0,8 Kw (6 pcs)

E) Pallet Corner Cutting

It is the section that cuts the four corners of the pallet according to the desired standards at the same time.

-Testere Diameter: 250 mm -Testere Movement: Pneumatic Piston

-Testere Motor Power: 2.2 Kw (4 pieces)

F) Pallet Chamfering

It is the section that milles the inner and outer corners of the lower boards of the pallet at an angle of 45 degrees.

-Six special chamfering blades -Motor Power: 2.2 Kw motor (6 pcs)

-Pallet Execution Engine: 0.75 Kw

-Total Electric Power: 33,55 Kw

-Cutting, Marking and Chamfering Units are single chassis

-Dimensions Maximum: Width: 2150 mm – Length: 6000 mm- Height: 1180 mm

-Weight: 2350 Kg

G) Rollover Unit

-Total Electric capacity: 2.2 kw

-Width: 2480mm- Length: 4400mm- Height: 940mm

-Working system: Mechanical

H) Pallet Stacking

It is the section stacking the pallets on top of each other.

-Stacking System: 2.2kw

-Maximum stacking: 40 pieces in a row -Width: 1850mm- Length: 2000mm

-Height: 1500 mm -Weight: 950 Kg

I) Discharge Conveyor

This is the section where the stacked pallets wait until they are picked up by the forklift.

Engine Power: 0,75 Kw